arla-1999-01-10 and arla-0.20: fprio_readin: cant open file cache/fprio: Operation not permitted

[Adrian Reyer]

Hi,

Introduction:
We had AFS from Transarc for Linux, but I needed a 2.2pre-Kernel and
they don't have their afs-binaries, yet. Somebody told me about arla
and there I went.

Compilation of arla:
./configure --prefix=/serv/services/arla --with-krb4=/serv/services/arla
make && make install

Problem-description:
Without xfs.o everything worked immediatly, but we need /afs
round here. There was only an empty directory, if /afs was mounted.

Solution:
The solution, after a glance at the debug output was a
touch /serv/services/arla/cache/fprio

Hardware:
Dual PII-400, Asus P2B-DS, SMC 9432 TX (rev 6), 512 MB RAM, 9GB system
disk, 40GB data (it's ftp.uni-stuttgart.de).

Software:
Linux, distribution RedHat-5.1, kernel 2.2.0pre6. arla-0.20 and
arla-1999-01-10

Unfortunately, I don't have the time, to go into the source, to send
you a patch, but of course, I attached the debug-output for you.

Thanks for writing arla,
			Heron
-- 
Adrian Reyer @ DU3               Adrian.Reyer at rus.uni-stuttgart.de
finger rusheron at helpdesk.rus.uni-stuttgart.de for PGP-Key
Key fingerprint = 70 7E 09 95 3A 43 63 39  B4 20 62 1C 82 A8 45 3A


[root at info6 arla-1999-01-10]# arlad -n --debug=almost-all
Sun Jan 10 18:19:50 1999: arlad: read_conffile: /serv/services/arla/etc/arla.conf
Sun Jan 10 18:19:50 1999: arlad: Arlad booting sequence:
Sun Jan 10 18:19:50 1999: arlad: connected mode: connected
Sun Jan 10 18:19:50 1999: arlad: ports_init
Sun Jan 10 18:19:50 1999: arlad: rx
Sun Jan 10 18:19:51 1999: arlad: conn_init numconns = 100
Sun Jan 10 18:19:51 1999: arlad: initconncache
Sun Jan 10 18:19:51 1999: arlad: cellcache
Sun Jan 10 18:19:51 1999: arlad: fprio
Sun Jan 10 18:19:51 1999: arlad: fprio_readin: cant open file /serv/services/arla/cache/fprio: Operation not permitted
Sun Jan 10 18:19:51 1999: arlad: volcache numvols = 100
Sun Jan 10 18:19:51 1999: arlad: using rxkad level auth
Sun Jan 10 18:19:51 1999: arlad: credcache numcreds = 100
Sun Jan 10 18:19:51 1999: arlad: fcache low_vnodes = 3000, high_vnodes = 4000low_bytes = 94371840, high_bytes = 104857600
Sun Jan 10 18:19:51 1999: arlad: cmcb
Sun Jan 10 18:19:51 1999: arlad: cm
Sun Jan 10 18:19:51 1999: arlad: arla init done.
Sun Jan 10 18:19:51 1999: arlad: running pinger
Sun Jan 10 18:19:51 1999: arlad: pre-creating nodes
Sun Jan 10 18:19:51 1999: arlad: worker 0 waiting
Sun Jan 10 18:19:51 1999: arlad: worker 1 waiting
Sun Jan 10 18:19:51 1999: arlad: worker 2 waiting
...